To Next PageTo Next Page
Need help?Do you have a question about the Genebre 5952 00 and is the answer not in the manual?
General warnings about mechanical movement, qualified personnel, and misuse of the positioner.
Ensure the air supply is dry, clean, and filtered to prevent damage.
Details on mounting the positioner onto the valve using provided accessories.
Instructions for connecting the positioner to the valve's transmission lever mechanism.
Procedure for modifying the SPAN adjustment device, with a safety caution.
Guidance on connecting the air supply to the positioner, with a safety caution.
Instructions for making the electrical connections for the input signal.
Steps to set the zero point of the positioner for the valve's closed position.
Procedure to adjust the range for 0% and 100% actuator stroke with signal.
How to switch between automatic and manual modes for the positioner.
Note that this adjustment is performed in the factory and requires no further manipulation.
Using air throttles to prevent oscillation in low air capacity actuators.
Calibration procedure for the position transmitter to match output signals.
Routine checks including assembly, electrical connections, screws, and air filters.
General| Input Signal | 4-20 mA |
|---|---|
| Type | Electro-Pneumatic |
| Output Signal | 0.2 - 1 bar |
| Supply Pressure | 1.4-7 bar |
| Ambient Temperature Range | -20°C to +60°C |
| Material | Aluminum |
