4
GENERAL HAZARDS
• For safety reasons, the manufacturer recommends that the installation, initial start-up and
maintenance of this equipment is carried out by a Dealer.
• Keep hands, feet, clothing, etc., away from drive belts, fans, and other moving or hot parts.
Never remove any drive belt or fan guard while the unit is operating.
• When working on this equipment, remain alert at all times. Never work on the equipment when
physically or mentally fatigued.
ELECTRICAL HAZARDS
• Do not handle any kind of electrical device while standing in water, while barefoot, or while
hands or feet are wet. DANGEROUS ELECTRICAL SHOCK MAY RESULT.
• In case of accident caused by electric shock, immediately shut down the source of electrical
power. If this is not possible, attempt to free the victim from the live conductor. AVOID DIRECT
CONTACT WITH THE VICTIM. Use a nonconducting implement, such as a dry rope or board,
to free the victim from the live conductor. If the victim is unconscious, apply first aid and get
immediate medical help.
• Never wear jewelry when working on this equipment. Jewelry can conduct electricity resulting in
electric shock, or may get caught in moving components causing injury.
EXPLOSION HAZARDS
• Do not smoke around the generator. Wipe up any fuel or oil spills immediately. Ensure that no
combustible materials are left in the generator compartment, or on or near the generator, as
FIRE or EXPLOSION may result. Keep the area surrounding the generator clean and free from
debris.
OPERATION AND MAINTENANCE
The operator is responsible for proper and safe use of the equipment. The manufacturer strongly
recommends that the operator read this Owner's Manual and thoroughly understand all instructions
before using this equipment. The manufacturer also strongly recommends instructing other users
to properly start and operate the unit. This prepares them if they need to operate the equipment in
an emergency.
It is the operator's responsibility to perform all safety checks, to make sure that all maintenance
for safe operation is performed promptly, and to have the equipment checked periodically by
an Authorized Service Dealer. Normal maintenance service and replacement of parts are the
responsibility of the owner/operator and, as such, are not considered defects in materials or
workmanship within the terms of the warranty. Individual operating habits and usage contribute to
the need for maintenance service.
Operating instructions presented in this manual assume that the standby electric system has been
installed by an Authorized Service Dealer or other competent, qualified contractor. Installation of
this equipment is not a “do-it-yourself” project.
Safety Rules
To Next Page
Loading...
Need help?
General