Generac Power Systems 10000EXL

Errata _
For Manual No. 96023 (Generac Model #9801-1)
One word in the first paragraph on page 6 in the section "240 Volt, 50 amp Receptacles" is incor¬
rect. Please replace that paragraph with the text shown below
240 Voit. 50 amp Receptacles
Use a compatible 3 prong plug with this receptacle
(Figure 11). Connect a 3-wire cord set rated 250 volts
at 50 AC amps to the plug. Use this receptacle to
operate 240 volts AC, 60 Hz, single phase loads
requiring up to 10,000 watts (10 kW) of power.
Errata _
For Manual No. 96023 (Generac Model #9801-1)
The caption for Figure 14 on page 12 in your manual is incorrect. Please replace the old figure with
that shown below. Generac regrets this inconvenience.