Reinstall the spray tip and in-line filter into the nozzle
extension.
6.
7. Reconnect the nozzle extension to the spray gun.
8. Reconnect the water supply,turn on the water, and
start the engine.
9. Test the pressure washer by operating with each of the
Quick Connect spray tips.
O-Ring Maintenance
Through the normal operation of your pressure washer,
o-rings, which keep the connections of the hoses and spray
gun tight and leak-free, may become worn or damaged.
Provided with your pressure washer is an O-Ring
MaintenanceKit which includes replacement o-rings, rubber
washer and water inlet filter. Refer to the instruction sheet
provided in the kit to service your unit's o-rings. Note that
not all of the parts in the kit will be used on your unit.
To remove a worn or damaged o-ring:
• Use a small flathead screwdriver to get underneath the
o-ring and pry it off.
ENGINE MAINTENANCE
Seethe engine owner's manualfor instructions on how to
properly maintain the engine.
_ AUTION! Avoid prolonged or repeated skincontact with used motor oil. Used motor oil has
been shown to cause skin cancer in certain
laboratory animals.Thoroughly wash exposed areas
with soap and water.
KEEPOUT OF REACH OF CHILDREN. DON'T
POLLUTE.CONSERVERESOURCES.RETURN
USED OIL TO COLLECTION CENTERS.
PREPARING THE UNIT
FOR STORAGE
Water should not remain in the unit for long periods of
time. Sedimentsor minerals can deposit on pump parts and
"freeze" pump action. If you do not plan to use the pressure
washer for more than 30 days,follow this procedure:
I. Flushdetergent siphoningtube by placing the filter into
a pail of clean water while running pressure washer in
low pressure mode. Flushfor one to two minutes.
2. Shut off the engineand let it cool,then remove high
pressure and gardenhoses.Disconnect spark plug wire
from spark plug,
3. Empty the pump of liquids by pulling the engine recoil
handle about 6 times.This should remove most of the
liquid in the pump.
4. Use Generac brand pump saver to prevent corrosion
build up andfreezing of pump.
5. Store unit in a clean,dry area.
Protecting the Pump
To protect the pump from damage caused by mineral
deposits or freezing, usethe Generac PumpSaverto treat
pump.This prevents freeze damageand lubricates pistons
and seals.
NOTE: Generac PumpSaver,model number 01559,isavailable
asan optional accessory.It is not included with the pressure
washer.
CAUTION!You must protect your unit from freezing
temperatures. Failure to do so will permanently damage
your pump and render your unit inoperable. Freeze damage
is not covered under warranty.
_ CAUTION! Read and follow all cautions and
warnings on the PumpSavercan label.Always wear
eye protection when using PumpSaver.
To use PumpSaver,make sure the pressure washer is
turned off and disconnected from supply water. Read and
follow all instructions and warnings given on the PumpSaver
container.
NOTE: PumpSaverwill drip from pump after treatment
and will stain wood and concrete.
NOTE: If PumpSaveris not available,draw RV antifreeze
(non-alcohol) into the pump by pouring the solution into a
3-foot section of garden hose connected to inlet adapter
and pulling recoil handle twice.
STORING THE ENGINE
See the engine owner's manual for instructions on how to
properly prepare the engine for storage.
I
14
To Next Page
Loading...
Need help?
General
