_ll ARNING! NEVERfill fuel tank completely full.
Provide spacefor fuel expansion.Wipe awayany fuel
spillagefrom engine and equipment before starting.
• Use fresh,clean unleadedautomotive gasolineand store in
approved, clean,covered containers. Use clean fill funnels.
NEVERuse"stale" gasoline left over from last season or
gasolinestored for long periods.
• Clean area around fuel fill cap,remove cap.
• Slowly add "UNLEADED" regular gasoline to fuel tank.
Use a funnel to prevent spillage.Slowly fill tank to about
1.5"below the bottom of the filler neck (Figure 7).
NOTE: The quick connect isshown connecting the high
pressure hoseto the spraygun.If you choose to use the
quick connect for the hose to pump connection, follow the
samedirections to attach quick connect from hose to pump.
• Attach the other end of the highpressure hose to the high
pressureoutlet on the pump (Figure 9).Tighten by hand.
Fuel
Install _el cap and wipe up any spilled gasoline.
Connect Hose and Water Supply to
Pump
IMPORTANT: You must assemblethe nozzle extension
and attach all hosesbefore you start the engine.Starting
enginewithout all hoses connectedand water supplied will
damagethe pump.
NOTE: Your pressure washer comes with a quick connect
that you can use to attach the high pressure hose to either
the spraygun or pump.
• Uncoil the high pressure hose and attach the femalequick
connect to one end of the hose.Attach the male quick
connect to the gun (Figure 8).
• Attach the end of the hoseto the baseof the spray gun
(Figure 8). Pull down on the collar of the quick connect,
slide fitting into the pump and let go of collar.Pull on
hose to be sure of a tight connection.
• Before you connectyour garden hose to the water inlet,
inspectthe inlet screen (Figure 10).Clean the screen if it
contains debris, replace it if it isdamaged.DO NOT
RUN THE PRESSUREWASHER IFTHE SCREENIS
DAMAGED.
• Run water through the garden hosefor 30 seconds to
cleanout any debris.Turn off water.
IMPORTANT: DO NOT siphon standing water for the
water supply.Use ONLY cold water (lessthan 100°F).
• Connect the garden hose (not to exceed 50 feet in
length) to the water inlet.Tighten by hand (Figure 10).
CAUTION! There MUST be at least ten feet of
unrestricted garden hose between the pressure washer
inletand anyflow shut off device, such as a'Y' shut-off
connector or other convenience-type water shut-off valve.
Damageto pressure washer resulting from disregarding this
caution will not be covered by the warranty.
• Turn ON the water and squeeze the trigger on the spray
gun to purge the pump system of air and impurities.
_ AUTION! Before starting the pressure washer,
be sure you are wearing adequateeye protection.
/
7
To Next Page
Loading...
Need help?
General
