Generac 3000PSI High Pressure Washer
11
High Pressure Washer
Pressure Washer Rinsing
WARNING: Be extremely careful if you
must use the pressure washer from a
ladder, scaffolding or any other relatively
unstable location. Pressure in a running
washer builds as you climb. When you
press the trigger, the recoil from the initial
spray could force you to fall. The high pres-
sure spray could also force you to fall if you
are too close to the cleaning surface.
For Rinsing:
Remove the chemical injector hose from the chemi-
cal bottle to stop detergent from flowing. Spray until
the detergent has cleared form the gun.
Keep the spray gun a safe distance from the area
you plan to spray.
Apply a high pressure spray to a small area and
then check the surface for damage. If no damage
is found, you can assume it is okay to continue
cleaning.
Start at top of area to be rinsed, working down with
same overlapping strokes as you used for cleaning.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for 3-5
minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach a tempera-
ture between 140145°F. When the water reaches
this temperature, the automatic cool down system
engages and cools the pump by discharging the
warm water onto the ground. This system prevents
internal damage to the pump.
GENERAL MAINTENANCE
RECOMMENDATIONS
The warranty of the high pressure washer does not
cover items that have been subjected to operator
abuse or negligence. To receive full value from the
warranty, operator must maintain high pressure
washer as instructed in this manual.
Some adjustments will need to be made periodi-
cally to properly maintain your high pressure
washer.
All adjustments in the Service and Adjustments
section of the engine owners manual should be
made at least once each season.
Once a year you should clean or replace the spark
plug, clean or replace the air filter and check the
gun and dual lance assembly for wear. A new spark
plug and clean air filter assure proper fuel-air mix-
ture and help your engine run better and last longer.
BEFORE EACH USE
Check engine oil level.
Check water inlet screen for damage.
Check high pressure hose for leaks.
Check detergent inlet hose and filter for damage.
Check gun and dual lance assembly for leaks.
GENERAC
The Reliable Ones
To Next Page
Loading...
Need help?
General
