Figure 11 — Removing and cleaning nozzle.
Remove additional debris by back flushing the
water supply through the dual lance (Figure 12).
Back flush between 30 to 60 seconds. Back flush
both lances by turning chemical valve handle.
Figure 12 — Backflushing the nozzle.
Reconnect the dual lance to the spray gun.
Reconnect the water supply, turn on the water, and
start the engine.
Test the pressure washer by operating with the
nozzle in the high and low pressure positions.
ENGINE MAINTENANCE
See the engine Owners Manual for instructions on
how to properly maintain the engine.
SERVICE AND
ADJUSTMENTS
See the Engine Owners Manual for instructions on
how to properly service and adjust the engine
PREPARING THE UNIT FOR
STORAGE
Water should not remain in the unit for long periods of
time. Sediments of minerals can deposit on pump
parts and freeze pump action. If you do not plan to
use the pressure washer for more than 30 days,
follow this procedure:
1.Flush the chemical injecting tube by placing the
injector filter into a pail of clean water while running
pressure washer and squeezing the spray gun trig-
ger with the dual lance in low pressure mode.
Flush for 1-2 minutes.
2.Shut off the engine and let it cool, then remove all
hoses.
3.Place Run/Stop Switch in STOP position.
4.Empty the pump of all liquids by pulling recoil
handle about 6 times. This should remove most of
the liquid in the pump.
NOTE: To protect the unit from freezing tempera-
tures, draw antifreeze fluid into pump by pouring
antifreeze fluid into a 3-foot section of garden hose
connected to the inlet adapter and pulling the recoil
handle twice. Use non-alcohol, RV antifreeze only.
5.Store in a clean, dry area.
STORING THE ENGINE
See the Engine Owners manual for instructions on
how to properly store the engine.
13
High Pressure Washer
Generac 3000PSI High Pressure Washer
GENERAC
The Reliable Ones
To Next Page
Loading...
Need help?
General
