Need help?Do you have a question about the Generac Power Systems NP Series and is the answer not in the manual?
General| Fuel Type | Gasoline |
|---|---|
| Starting System | Recoil Start |
| Frequency | 60 Hz |
| Engine | Generac OHV Engine |
| Voltage | 120V |
Engine exhaust contains chemicals known to cause cancer, birth defects, or reproductive harm.
Important information and procedures for installing Generac products for safety and reliability.
Outlines the manual's objectives, content, and intended audience for installation.
Stresses compliance with safety rules to prevent injury, death, or equipment damage.
Lists relevant industry standards and codes for installation and use.
Details the Generac NP and Q series air-cooled generators for RVs.
Explains the generator's operating speed and governor function.
Provides details on engine type, cylinders, displacement, and governor.
Specifies the type of gasoline and propane fuel required for operation.
Lists fuel consumption rates for various models at different load levels.
Details the type and capacity of engine oil to use.
Guidelines for selecting a suitable and accessible location for the generator.
Requirements for securely mounting the generator to the vehicle frame.
Describes methods for suspending the generator below the support tubing.
Details minimum clearance needed around the generator within its compartment.
Specifies materials and methods for building a generator compartment.
Explains how air circulates for engine and component cooling.
Specifies the minimum required free air inlet area for proper cooling.
Requirements for fuel tank sharing or separate installation for the generator.
Guidelines for installing rigid and flexible fuel lines.
Key points for installing propane systems safely and correctly.
Lists parts not included in the factory-supplied propane system.
Information on mufflers, spark arrestors, and their maintenance.
Describes the available "bottom-out" and "side-out" exhaust kits.
Specifies requirements for the generator's AC output junction box.
Rules for selecting wire size, type, and routing for generator connections.
Details how to connect the generator's AC output leads.
Step-by-step instructions for reconfiguring the generator for dual voltage output.
Details the type, capacity, and cold cranking amps for the battery.
Guidance on choosing appropriate battery cables based on length and temperature.
Instructions for correctly connecting battery cables to the generator.
Guidelines for installing the battery in a vented compartment.
Pre-operation checks including oil, fuel, and leak inspections.
Steps for starting the generator for the first time after installation.
How to measure and verify output voltage and frequency without load.
Verifies proper generator placement, support, and restraint.
Confirms proper compartment construction, sealing, and insulation.
Ensures adequate airflow and proper inlet opening.
Verifies compliance and proper installation of the gasoline fuel system.
Confirms code compliance and safe installation of the exhaust system.
Checks propane system installation, pressure, and leak testing.
Ensures electrical compliance, proper wiring, and bonding.
Verifies correct battery, cables, connections, and ventilation.
Confirms that all post-installation tests have been completed.
To Next Page