General Pipe Cleaners Speedrooter 92 - Ground Fault Circuit Interrupter (GFCI)

Speedrooter 92
®
Cable Application Chart (Table 1)
Cable Size Pipe Size Typical Applications
3/4”
(Large Drum)
4” to 10” Large Drains, Long Runs, Roots
5/8”
(Large Drum)
3” to 6” Floor Drains, Roots
5
Cutter Application Chart (Table 2)
Cutter Cat. # Typical Applications
Cutters for 5/8” and 3/4” Cables
Spear
Head
SHD
Starting Drill—gets water
flowing.
2”
U-Cutter
2UC For Cutting and Scraping
3” & 4”
Side
Cutter
Blades
3SCB
&
4SCB
For Cutting—Scraping walls of
pipe.
3” Heavy
Duty Saw
Blade
3HDB For Cutting Roots
4” Rotary
Saw Blade
4RSB For Cutting Roots
Large
Retrieving
Tool
RTR-2
For removing loose objects or
broken cables.
26” Flexible Leader LE-3
Helps cable get through tight
traps and bends.
Note: There are no fixed rules for what cutter to use. If one tool
doesn’t take care of a stoppage, simply try another.
FEATURES
NOTE: Do not operate machine if warning labels on the switch box
and power cord are missing or illegible.
Adjustable Height Handle
Motor
Switch
V-Belt
Truck
Loading
Wheel
Drum
Flexitube Spring Distributor Tube
Belt Guard
Feed Pressure
Control Knob
Feed
Control
Lever
Cutter
Stair
Climbers
Wheel
Brake
Cord Wrap
Guide
Tube
Extension
THE SECTION OF CORD BETWEEN THE WALL PLUG
AND THE GFCI IS NOT IN THE PROTECTED CIRCUIT.
Ground Fault Circuit Interrupter (GFCI)
Your machine is equipped with a ground fault circuit interrupter, which
protects you against shock if a short circuit should occur. Check that
receptacle is properly grounded. Test the GFCI before each use.
1. Plug into 120-volt receptacle.
2. Push test button. Indicator light will go out and power to machine
should cut off.
3. If light does not go out when test button is pushed, DO NOT USE
THE MACHINE until proper repairs can be made.
4. To restore power after test, push reset button. With the reset
button depressed, if the machine doesn't start, stops while run-
ning, or if the operator experiences a mild shock, DO NOT USE
THE MACHINE! Tag the machine out of service and take it to a
motor repair center or return it to the factory for repairs.