UNPACKING
Carefully unpack and remove the saw from the crate. All
other components and accessories are packed inside
the saw cabinet. Check for damaged or missing items as
per the list of contents below.
NOTE: Please report any damaged or missing items to
your General® International distributor immediately.
LIST OF CONTENTS QTY
BASIC FUNCTIONS
This cabinet saw has been designed for cutting solid wood as well as manufactured wood materials such as ply-
wood, wood panelling, particleboard, mdf and other wood based by-products. This saw is not designed for cutting
metals nor for cutting any materials other than wood or wood based stock.
This saw is designed for use with maximum 10" (254mm) diameter blades having a center hole diameter of 5/8".
The blade can be raised to cut a maximum stock thickness of 3 1/8" with the blade set 90 degrees to the table. The
blade can be tilted up to 45 degrees to the right for bevel cuts to a maximum stock thickness of 2 1/8". Using any
standard aftermarket 8" diameter stacked dado blade set (not included), the maximum dado cutting capacity of
this saw is 13/16". Note: for safer dado cutting, an optional dado table insert (part number # 350-3) can be purcha-
sed through your
General
/
General
International distributor.
To encourage safety through the proper use of either the supplied riving style splitter/blade guard assembly or the
European style riving knife the 350R saw has been designed with a quick install/quick release feature allowing the
user to install or remove either of these safety components in seconds.
ADDITIONAL REQUIREMENTS FOR SET UP
• Phillips Screwdriver
• 1/2", 7/16" and 9/16" and open end wrench
• 1/8" Allen key
• Square
8
or
To Next Page
Loading...
