Version: 2020-09-04
107
Copyright of the European Union is effective (Copyright EU) (c) 2019 GENEREX Systems GmbH, Hamburg, Germany, All rights reserved
TEL +49(40)22692910 - EMAIL generex@generex.de - WEB www.generex.de (This and all other product datasheets are available for download.)
Note:
The port state to be switched to is completely independent to the actual switching state. If the port is set to high/on and you switch the
port to high, it will be switched accordingly again. Timing configuration is similar to other jobs
Switch an output
With CON_R_AUX 4, it is possible to switch a potential-free relay contact on activation:
Manually switched
➔ Manual switching on / off of a port
Each channel defined as output can be manually switched by pressing the Switch on button at AUX monitor.
AUX status monitor
For monitoring, CS141 provides an AUX Status Monitor. To open the AUX Status Monitor, select AUX Monitor from the top-level menu:
Figure: CON_R_AUX 4 AUX Monitor: Port 1 is inverted, port 2 is output and port 3/4 is default
1: Port
Port number shows the current port.
2: Usage
Usage shows whether the used port is configured as input or output.
3: Inverted
Inverted provides information about the behavior of how the connected device should be interpreted.
There are two valid states:
Inverted: No
The connected contact must normally be closed.
Inverted: Yes
The contact is normally considered "open". This function can thus be used to invert the alarm behavior.
4: State
State displays the current switching state. Please note this state will change according to the LEDs at CON_AUX4 and CON_R_AUX4.
Due to the fact web technology is used, there is a time delay based on refreshing time of the browser.
5: Switch on /off
If a port is defined as output, this button will toggle the current state of the output.
To Next Page
Loading...
