Version: 2020-09-04
162
Copyright of the European Union is effective (Copyright EU) (c) 2019 GENEREX Systems GmbH, Hamburg, Germany, All rights reserved
TEL +49(40)22692910 - EMAIL generex@generex.de - WEB www.generex.de (This and all other product datasheets are available for download.)
The external sensor
You do not need to remove the module board. Just remove the connector oft he sensor cable.
The connector is coded so that it only fits in one direction on the module. When carrying out the work, make sure that the ESD
guidelines are observed to prevent electrostatic discharge during assembly - these can damage electronic components.
5. Re-assembling the module
Modules with the internal sensor
Place the rear retaining bracket into the module housing and snap the front retaining clips into place with slight pressure.
Modules with an external sensor
First place the strain relief at the corresponding recess in the upper module shell:
Then reassemble the module accordingly. Ensure when putting the two shells together, the cable of the external sensor is
behind the plastic web for the module screw to avoid damaging it when using a DIN rail:
To Next Page
Loading...
