Version: 2020-09-04
38
Copyright of the European Union is effective (Copyright EU) (c) 2019 GENEREX Systems GmbH, Hamburg, Germany, All rights reserved
TEL +49(40)22692910 - EMAIL generex@generex.de - WEB www.generex.de (This and all other product datasheets are available for download.)
Network settings
➔ MAC-Address of yourCS141
➔ Configured IP Address
➔ Configured Subnet Mask
➔ Configured Gateway
➔ Configured DNS-Server
The network settings show the current configuration:
MAC address: The Media Access Control is a worldwide unique address to identify a network device. This address is
given by the manufacturer and cannot be changed.
IP-Address: Shows current IP address assigned to this device. In configuration mode, the default IP 10.10.10.10 is set,
even if the IP address configured by administrators differs.
Gateway: Defines the network device that is allowed to accept and serve requests to the Internet. By default, the
configuration mode uses IP 10.10.10.1
DNS The DNS server provides the translation of names and IP addresses into reachable destinations within
networks. In configuration mode, it is the IP 10.10.10.1
Connectivity
➔ Devices according to COM 1
➔ Services this CS141 device provides
Connectivity allows a general overview of the options the CS141 currently provides.
Devices thereby merely indicates a UPS can be connected hardwarely to the CS141, but not the kind of model. Services define the
software-related services installed and started on the CS141 to communicate with additional devices as well as software.
Switch to operating mode
After completing basic configurations, move the slider to the desired position or set the DIP switches accordingly
to enable regular operating mode. After reboot, the device will run in desired mode. if necessary, the device can fall back to
configuration mode by setting DIP Switches or sliding switch into configuration mode.
Note that the current switch position will generally take effect after rebooting CS141.
The table below shows the regular operation modes available to the CS141 family.
Sliding switch to center position / DIP switch 1+2 OFF:
After booting, the CS141 will run in configuration mode. Hard-coded default IP
address 10.10.10.10 is active.
Sliding switch to right position/ DIP 1 OFF + DIP 2 ON:
After booting DHCP is active and IP address will be assigned automatically. To
identify assigned IP address check MAC address of CS 141.
.
Sliding switch to left position / DIP 1 to ON + DIP 2 OFF:
After booting, manually configured network settings will take effect.
To Next Page
Loading...
