Version: 2020-09-04
83
Copyright of the European Union is effective (Copyright EU) (c) 2019 GENEREX Systems GmbH, Hamburg, Germany, All rights reserved
TEL +49(40)22692910 - EMAIL generex@generex.de - WEB www.generex.de (This and all other product datasheets are available for download.)
#OUTFREQ0/1/2 Ausgangsfrequenz in Hz
#OUTPHASES Anzahl Ausgangsphasen
#OUTPOWER0/1/2 Last in Prozent
#OUTPUT_VOLT0/1/2
#OUTPUTCURRENT0/1/2
#OVERLOAD overload
#PHASES phases
#POWER power of the UPS
#RECHARGETIME time needed for a full recharge of batteries
#RESTORETIME restore time
#RUNTIME uptime since last comminssioning
#SECONBAT() seconds on battery
#SELFTESTDATE date of the last self test
#SERVER IP address of the SNMP manager
#STATUS system state
#SYSDATE() system date
#SYSTIME() system time
#TEMPDEG temperature in °Celsius
#TIMEZONE time zone
#VOLTAVAI USV bezogen, // USV hat eine Möglichkeit, die Inputvoltage abzufragen
Sensors and devices
For this configuration step, navigate to the following menu items:
Depending on used model, the CS141 offers to connect external sensors and devices sensors.
These CS141 models support the connection of sensors:
- CS141 SC
- CS141 L
- CS141 R2
- CS141 Mini
SM_T_H_COM Standalone Sensor
This example shows how to configure the SMT_H_COM standalone sensor, a combined
temperature and relative humidity sensor available for CS141.
The supplied standard length of the cable to connect the sensor to CS141 is 1.8 meters.
If required, cable length up to 30m can be used.
Wiring the external sensor
Connect CS141 COM 2 to SM_T_H_COM. CS141 does not require to reboot.
Basic Setup Configuration
Under Devices / Setup, go to Configuration and change the setting at COM2 from none to Sensor.
After changing, define type of sensor connected to CS 141.
In this case, select SM_T_H_COM:
To Next Page
Loading...
