Version: 2020-09-04
84
Copyright of the European Union is effective (Copyright EU) (c) 2019 GENEREX Systems GmbH, Hamburg, Germany, All rights reserved
TEL +49(40)22692910 - EMAIL generex@generex.de - WEB www.generex.de (This and all other product datasheets are available for download.)
Press Apply to start the corresponding service. The status bar indicates the process.
While Sensor is restarting, the according menus will be prepared. Please wait until the Sensor mark is set to “OK” before entering the
configuration dialog of the sensor.
Configuration of zhe SM_T_H_ COM combi sensor
Under the main tab Devices, open the sub menu Sensors and click on Setup. This will open the Sensor configuration dialog.
Name
At Name, enter the name, a description or an installation place of the sensor. The Name will appear at
the sensor monitoring screen.
Thresholds Low / High und Alarm functions
The SM_T_H_COM combinated sensor provides two different
sensor types. The temperature sensor opereates between -25
° C and +100 ° C. The humidity sensor measures humidity
range 0% and 100%. After installing the sensor, the maximum
sensor range will be shown without a range restriction or
notification markers. In order to define an alarm behavior, the CS141 needs information about the critical values and if necessary, a
configured measuring range.
Please note the following rules during configuration:
1. The pre-alarm must be lower than the critical alarm setting.
2. The relative humidity is a minimum of 0% and a maximum of 100%
3. The coldest temperature value is -25 ° C and the highest value + 100 ° C
Note:
As long as the checkboxes for the according alarm is not set, the respective alarm marker. Due to this fact it is possible to configure
notification and alarm values and test the settings before activating.
Offset - Settings
Although the SM_T_H_COM is already a calibrated sensor, the operating
environment may require different values. The correction values will be
defined via offset settings:
These values will be added or substracted from the value the sensor
provide. This allow to harmonize the sensor values with callibrated
external measurings and to adapt the sensor for special operating
conditions.
Sensor-related system events
The CS141 provides defining system jobs via connected sensors. The available system events refer to the measured values of the
connected sensors. The following events are available for SM_T_H_COM.
SM_T_H_COM Temperature High
To Next Page
Loading...
