English
WARNING: The charging battery acid is an aggressive and corrosive liquid,
use protective gloves and goggles before beginning battery preparation.
WARNING: Keep children and animals away from the area while performing
this operation, their actions can be unpredictable.
CAUTION: Do not mix the acid with other liquids or different acids, do not use
an acid other than the one supplied with your machine.
1 Remove the battery protection sticker.
2 Remove the plastic cap from the acid containers. Keep them. You will need
them later.
CAUTION: Do not puncture or
remove the safety seals from the
acid containers.
3 Press the acid containers against the battery so the seals are punctured by the
intended orifices.
4 Tap the acid containers softly so the acid is poured faster.
5 Use the plastic caps we kept in item "2" to close de battery definitively.
6 Install the battery by inverting the removal steps on the generator riser and fix
it to fastening rods.
7 Connect the generator supply wires on the battery terminals.
NOTE: Respect the cable polarities, connect the red cable (+) to the red
terminal
(+) of the battery and the black cable (-) to the negative (-) of the battery.
NOTE: Extreme precautions so as to not make unwanted contact with the
battery terminals and cables, among them or against a metallic part of the
machine.
To Next Page
Loading...