Generic TR 125 - Acceleration, Braking, and Break-in Period

OPERATION AND IMPORTANT POINTS

Ɣ$YRLGKDUGRUVXGGHQEUDNLQJ
(especially when cornering)
otherwise the motorcycle may
skid.
Ɣ5DLOURDGFURVVLQJVVWUHHWFDU
rails, iron plates on road cons-
truction sites, and manhole co-
vers become extremely slippery
when wet. Therefore slow down
when approaching such areas
and cross them with caution.
Ɣ.HHSLQPLQGWKDWEUDNLQJRQD
ZHWURDGLVPXFKPRUHGLI¿FXOW
Ɣ5LGHGRZQKLOOVORZO\EHFDXVH
braking downhill can be very
GLI¿FXOW
Ɣ:KHQ\RXEUDNHWKHEUDNH
discs, brake pads and the brake
ÀXLGKHDWXS7KHKRWWHUWKHVH
parts get, the weaker the bra-
king effect. In extreme cases
the entire braking system might
malfunction.
ƔTake time to become familiar
with the braking system.
Acceleration and deceleration
The speed can be adjusted by ope-
ning and closing the throttle. To in-
crease the speed turn the throttle
grip in direction (a). To reduce the
speed turn the throttle grip in direc-
tion (b).
Braking
1. Release the throttle.
2. Apply the front and rear brake at
the same time.
3. Apply the clutch lever gradually
increasing the pressure.
Engine break-in period
FoUWKH¿UVWNPGULYLQJGRQRW
rev the engine or make it exceed
80% of the maximum speed in any
JHDU,WLVUHFRPPHQGHGQRWWRGULYH
the motorcycle at full throttle.
Top speed for the running-in period of the motorcycle
a
b
!
WARNING
'LVWDQce
Gear
Speed limit (km/h)
0 -
300km
10 24 30  40 
300 -
NP
 30  40  
-
1000km
 30 40   
1000 -
NP
     
1. 2. 3. 4. 5. 6.