2) Manual infrared mode: This is the default setting, and you can activate
the IR LEDs and lens by holding the button for 1 second. Once
activated, you will see the IR LED turn on and hear the lens activate. To
turn off the IR LED, simply hold the button again for 1 second.
Taking Photos
In standby mode, press the button to take a snapshot. You will hear a
‘click’ noise and the LED working status indicator will flash red once,
meaning the photo has been stored. The photo resolution and quality can
be changed in the settings.
Burst Photo Mode
To take burst photos instead of single standalone photos, go into the
settings menu by pressing (default passcode is 000000) and finding the
[Burst] option. Make a selection of 2, 3, 5, 7, 10, 15, 20, or 30. Now, when
you press , the camera will take photos according to the quantity of
bursts selected.
To Next Page
Loading...