or off, go into the settings menu by pressing (default passcode is
000000) and select [Pre-record] option. Press the button to select ON
or OFF.
Post-recording
Delay recording works very similar to pre-recording, only this option will
continue recording for a set number of seconds after the button has
been pressed. To turn this feature on or off, go into the settings menu by
pressing (default passcode is 000000) and select [Post record] option.
Press the button to make a selection.
Disabling “Recording Started” Audio Prompt
Go into the settings menu by pressing (default passcode is 000000) and
select the [Record Warning] option. Press the button to select ON or
OFF.
Recording Audio Only
In standby mode, press the button at any time to start audio recording.
Audio recording will initiate a “beep” noise along with a vibration and an
LED indicator. Simply press the button again to stop audio recording
at any time.