Genesis 12t User Manual

16
1616
16
~ÄëçäìíÉ=ÑáÇÉäáíó™
The best amplifier for this application is a Class-D switching amplifier.
One of the reasons a Class-D amplifier is optimum for this application
is that it has a dramatically increased efficiency, especially at lower
frequencies. A typical Class A/B amplifier is only 50% efficient. A
Class-D amplifier, on the other hand, can be 90% efficient. A Class-D
amp also puts out more power with less heat and less power
consumption; ideal for use as a subwoofer amplifier.
The S2/12t uses a proprietary, ultra-efficient, discrete MOSFET
switching amplifier with output capability of up to a full kilowatt. The
design provides extraordinary control with high-damping and great
thermal stability, so that you can play the most demanding sources
continuously at high volume.
The Transducers
The transducer used in a servo system must be strong enough to
withstand the high current approach of the servo, and yet delicate and
light enough to react extremely quickly. The S2/12t subwoofer features
two 12-inch woofers that are designed with ribbed aluminum cones,
that are lightweight and yet inherently stiff. Our aluminum cones exhibit
no resonance or cone flexure anywhere near the frequencies at which
the subwoofer operates. The lowest break-up mode (where there can
be any chance of distortion at all) is at 6,000Hz – far above the 25Hz to
120Hz frequency response of the S2/12t. Therefore, the driver is a
perfect piston within the frequencies used, and exhibits very low cone-
breakup distortion.

Genesis 12t Specifications

Audio Specifications

frequency response	20Hz to 120Hz +/- 1dB
extended frequency response	16Hz to 180Hz -3dB, +2dB

Ports & Interfaces

high-level inputs	left and right with 5-way binding posts
low-level inputs	left and right, single-ended RCA and balanced XLR
LFE low-level mono inputs	single-ended RCA and balanced XLR

Weight and Dimensions

dimensions	31” x 21” x 16” (w x h x d)
dimensions_metric	533mm x 787mm x 406mm
weight	83.5 lbs (38 kg)