English
4-1/2" Compact Circular Saw
Operator’s Manual GCS445SE
• Do not use tool if switch does not turn it on or off.
.
•
Turn power tool off, and disconnect the plug
.
.
•
Store idle tool out of reach of children and other inexperienced persons.
•
Maintain power tools with care.
•
Use recommended accessories.
•
Keep cutting tools sharp and clean.
.
•
Feed the work piece in the correct direction and speed.
•
Never leave the tool running unattended, turn the power off.
• Never start the power tool when any rotating component is in contact with
the work piece.
WARNING: Use of this tool can generate and disburse dust or other airborne
particles, including wood dust, crystalline silica dust and asbestos. Direct particles
away from face and body. Always operate tool in a well-ventilated area and provide
for proper dust removal. Use dust collection system wherever possible. Exposure
to the dust may cause serious and permanent respiratory or other injury, including
silicosis (a serious lung disease), cancer, and death. Avoid breathing the dust, and
avoid prolonged contact with the dust. Allowing dust to get into your mouth or eyes,
or lay on your skin may promote absorption of harmful material. Always use properly
fitting NIOSH/OSHA approved respiratory protection appropriate for dust exposure,
and wash exposed areas with soap and water.
SERVICE
Have your power tool serviced by a qualified repair person
.
•
Service your power tool periodically.
SAVE THESE INSTRUCTIONS
EXTENSION CORDS
Grounded tools require a three wire extension cord.
To Next Page
Loading...
Need help?
General
