Genesis GCS445SE - Assembly and Adjustments; Blade Installation; Removing the Blade; Adjusting the Depth of Cut

9
English
ASSEMBLY AND ADJUSTMENTS
WARNING: Always be sure that the tool is switched off and unplugged before
adjusting, adding accessories, or checking a function on the tool.
WARNING: 4-1/2” is the maximum blade capacity of your saw. Never use a
blade that is too thick to allow the outer flange washer to fit properly on the spindle. Too
thick a blade will prevent the blade bolt from securing the blade on the spindle. Larger
diameter blades will contact the blade guards. Either situation could result in a serious
accident.
BLADE INSTALLATION ( FIG 2,3,4 )
• 
•       

•

•
•     


•
•
•

REMOVING THE BLADE (FIG 2,3,4)
 
 

 

 
 
 
ADJUSTING THE DEPTH OF CUT (FIG 5)
 
 
 

 OR
 




 
NOTE

BEVEL ANGLE ADJUSTMENT (FIG 5)
 
 
 
 

FIG 2
19
FIG 3
9
FIG 4
13
13b
11
FIG 5
10
16
17
3