Genesis GDP1005A - ADJUSTMENTS; ADJUSTING SPEEDS AND BELT TENSION; SETTING DRILL DEPTH

English
10" Drill Press
Operator’s Manual GDP1005A
10
ADJUSTMENTS
WARNING: Always be sure that the tool
is switched off and unplugged from the power
source before adjusting, adding accessories, or
checking a function on the tool .
ADJUSTING SPEEDS AND BELT TENSION
(FIG 9, 10)
1. Unplug the machine from the power source.
2. Open the drill press pulley cover (1).
3. Loosen the belt tension knobs (13) on the both sides of the drill
press head assembly.
4. Pull the motor (2) as close to the column (C) as possible.
5. Change the belt locations according the speed chart (FIG 10)
and speed you desire.
6. Push the motor away from the column (C) to tension the belt.
7. The belt (17) should be tight enough to prevent slippage. Correct tension is set if the belt flexes about 1/2"
when thumb pressure is applied at the midpoint of the belt between the pulleys.
8. Tighten the belt tension knobs (13).
ADJUSTING TABLE HEIGHT (FIG 11)
1. Loosen the table support lock handle (7).
2. Turn the crank handle (6) to raise or lower the table to the
desired height.
3. Tighten the lock handle (7) before drilling.
ROTATING THE TABLE ASSEMBLY
AROUND THE COLUMN (FIG 11)
1. Loosen the table support lock handle (7).
2. Rotate the table assembly (8) around the column to the
desired position.
3. Tighten the lock handle (7) before drilling.
ADJUSTING TABLE BEVEL (FIG 11,12)
The table can be tilted 0° to 45° to the left and right.
1. Loosen the bevel lock bolt (B4) with a wrench.
2. Tilt the table (8) to the desired angle, using the bevel scale
(19) as a basic guide.
3. Re-tighten the bevel lock bolt (B4).
4. To return the table to its original position, loosen the bevel
lock bolt. Realign the bevel scale (19) to the 0° setting.
5. Tighten the bevel lock bolt (B4) with the wrench.
SETTING DRILL DEPTH (FIG 13)
The drill depth scale (18) is located on the hub (A4). See FIG
13. The scale pointer (A5) indicates the spindle travel distance.
To stop the drill at a specific depth for consistent and repetitive
drilling:
1. Loosen the depth scale lock (A6)
FIG 13
A6
A5
18
A4
FIG 10
FIG 9
1
2
13
1
C
17
FIG 11
7
6
19
8
FIG 12
B4
8