11
English
2. Rotate the scale hub (A4) until pointer (A5) is aligned to the
desired depth on the scale.
3. Tighten the depth scale lock (A6). The chuck will stop after
traveling downward to the distance selected.
ADJUSTING THE RETURN SPRING
(FIG 14)
The return spring is adjusted at the factory and should not need
further adjustment. If adjustment is deemed necessary:
1. Unplug the machine from the power source.
2. Loose the two jam nuts (A7). Do not remove.
3. Firmly hold the coil spring cover (A8). Pull out the cover and
rotate until the pin (A9) on motor head engages the next notch
in the cover. Turn the cover clockwise to decrease tension and
counterclockwise to increase tension.
4. Tighten two jam nuts. Do not over-tighten. The jam nuts should
be tightened against each other.
SQUARING THE TABLE TO THE HEAD
(FIG 15)
1. Install a 3" long drill bit into the chuck (4) and tighten.
2. Raise and lock the table (8) about 1" from the end of the drill
bit.
3. Place a combination square on the table as shown. The drill bit
should be parallel to the straight edge of the square.
4. If an adjustment is needed, loosen the bevel lock bolt
(B4-FIG 12 ) with a wrench.
5. Square the table to the bit by tilting the table.
6. Tighten the bevel lock bolt (B4-FIG 12) when square.
OPERATION
ON/OFF SWITCH (FIG 16)
1. To turn the tool ON, move the switch (3) to the"ON" position.
2. To turn the tool OFF, move the switch (3) to the "OFF" position.
3. To lock the switch in the OFF position, remove the yellow safety
key from the switch. Store the key in a safe place.
LED WORK LIGHT SWITCH (FIG 17)
The drill press comes with a built-in LED work light to illuminate
work surface. The On/Off switch (22A) is located on the left side
of the drill press housing. See figure 17.
• To turn the LED work light On, press the button “I”.
• To turn the LED work light Off, press the button “O”.
INSTALLING OR REMOVING BITS (FIG 18)
WARNING: To reduce the risk of injury,
only use the chuck key provided with this drill
press or a duplicate of it. This chuck key is self-
ejecting and will “pop” out of the chuck when
you let go. This action is designed to help prevent
throwing of the chuck key from the chuck when
power is turned “ON”. Do not use any other key as
a substitute; order a new one if damaged or lost.
To install a drill bit (FIG 18)
1. Unplug the drill press.
FIG 16
3
SAFETY
KEY
FIG 15
8
4
FIG 14
A9
A8
A7
FIG 18
4
I
FIG 17
22A
To Next Page
Loading...
