5
Installing Accessories
This flash unit is not powered by itself, but draws power from the
GENESIS PowerPort Duo 1000 external battery pack, CF0200, CF201,
CF0202 (sold separately)
Installing Flash Tube
Connecting to Battery Pack
Connecting Flash to Camera
2. Match the red dot on the base of the Flash
Tube with the red dot in the Tube Socket
(4). Push the Flash Tube in until it is
securely seated into the socket.
1. Remove the Reflector or other accessories
from the Flash Head.
1. Before connecting, make sure that the
Battery Pack is turned off.
2. Plug one end of Power Cable into Power
Socket (6) of the Flash Unit, and insert the
other end into the output socket of the
Battery Pack.
3. Turn on the Battery Pack.
1. Loosen locking ring on the Hot Shoe Mount.
2. Slip the Hot Shoe Mount of the flash unit into the camera's Hot Shoe.
3. Secure flash unit by tightening the locking ring.
To Next Page
Loading...