Genesis GLCS2055A - Assembly and Adjustments; Blade Installation and Removal; Adjusting Cutting Depth and Bevel Angle

English
20V MAX Lithium-ion Circular Saw
Operator’s Manual GLCS2055A
ASSEMBLY AND ADJUSTMENTS
WARNING: Always be sure that the tool is switched off and the battery is
disconnected before adjusting, adding accessories, or checking a function on the tool.
WARNING: 5-1/2” is the maximum blade capacity of your saw. Never use a
blade that is too thick to allow the outer flange washer to fit properly on the spindle.
Too thick a blade will prevent the blade bolt from securing the blade on the spindle.
Larger diameter blades will contact the blade guards. Either situation could result in a
serious accident.
BLADE INSTALLATION ( FIG 2 )
• 
• 
• 

• 
• 

• 
• 
• 

REMOVING THE BLADE
 
 
 
 
 
 
ADJUSTING THE DEPTH OF CUT
 
 
 
 OR
 


 
NOTE: 

BEVEL ANGLE ADJUSTMENT
 
 

 
 

LINE-OF-CUT INDICATORS
 
 
 
 

10
a
9
9b
16
11
FIG 2