9
English
ADJUSTING MATERIAL SUPPORT HEIGHT (See FIG 11)
1. Loosen the material support locking knob (5).
2. Adjust the height of the material support (7) so its support roller (3) is level with the table top surface of the
miter saw.
3. Retighten the knob (5) and repeat on the other side.
WARNING: To reduce the risk of injury, make sure the material supports are
adjusted so that workpiece sits flat on the miter saw table. Workpieces that do not sit flat
could cause the blade to bind during cutting.
USING THE WORK STOPS (See FIG 11)
Raise the work stop (4) whenever you need to make repetitive cuts of the same length.
NOTE: To avoid a greater risk of binding or pinching, do not use both work stops at the same time.
To Raise the Work Stop, simply just flip the work stop up as shown in FIG 11.
USING WHEELS TO TRANSPORT (See FIG 12)
The wheels make it easy to transport the stand with or without saw mounted, as shown in FIG 12.
1. Fold all four legs up, reversing the instructions in the previous section "Unfolding the Legs".
2. Make sure the saw and bracket assembly is locked securely on the stand rails.
3. Lift the end of stand body to transport.
WARNING: Always using the stand body to lift. Do not use the extension rail
or material support to lift the stand. A loosened locking knob during the transportation
could cause serious personal injury.
MAINTENANCE
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING: Do not at any time let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc., come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in serious personal injury.
TWO-YEAR WARRANTY
This product is warranted free from defects in material and workmanship for 2 years after date of
purchase. This limited warranty does not cover normal wear and tear or damage from neglect or
accident. The original purchaser is covered by this warranty and it is not transferable. Prior to returning
your tool to store location of purchase, please call Toll-Free Help Line for possible solutions.
TOLL-FREE HELP LINE
For questions about this or any other GENESIS™ Product, please call Toll-Free: 888-552-8665.
Or visit our web site: www.genesispowertools.com
©Richpower Industries, Inc. All Rights Reserved
Richpower Industries, Inc.
736 Hampton Road
Williamston, SC 29697
Printed in China, on recycled paper
To Next Page
Loading...
Need help?
General
