Genesis GSS160 - Blade Selection and Installation; Blade Installation Procedure; Choosing the Right Blade

English
16" Variable Speed Scroll Saw
Operator’s Manual GSS160
WARNING: Make sure the blade with the teeth to the front of the saw
and pointing downward.

 NOTE:

NOTE:







NOTE
 WARNING: Always be sure that the tool is switched off and unplugged
from the power source before adjusting, adding accessories, or checking a
function on the tool .
Blade selection







Teeth/
Inch
Width Thick-
ness
Speed
(Strokes/Min.)
Material Cut
10 0.110" 0.020" 1200-1600 Popular size for cutting hard and soft
woods 3/16 in. up to 2 in. Plastics,
paper, felt, bone, etc.
15 0.110" 0.020" 600-1200 Wood, plastic, extremely thin cuts on
materials 3/32" to 1/2" thick
18 0.095" 0.010" 400-600 For tight radius work in thin material
3/32" to 1/8" wood veneer, wood,
bone, Fiber, ivory, plastic, and etc.
FIG 6
1
2
3
4