Genesis GSS160 - Operation Guide; ON;OFF Switch and Speed Control; Freehand Cutting Procedure

English
16" Variable Speed Scroll Saw
Operator’s Manual GSS160
OPERATION
ON/OFF Switch (FIG 10)




Variable Speed Dial (FIG 10)





NOTE:

Dust Port (FIG 10)


Basic Scroll Saw Operation:
WARNING: Read and understand the following items about your scroll
saw before attempting to use the saw.
NOTE: Use scrap lumber to check the settings and to get the feel of operating
the saw before attempting regular work.





GENERAL FREEHAND CUTTING






WARNING: Never start the saw when the blade is in contact with the
work piece.
WARNING: Do not force the leading edge of the work piece into the
blade. The blade will deflect, reducing accuracy of cut, and may break.




FIG 10
1
3
2