Genesis GV80 - Electronic Parking Brake (Epb)

DRIVING
Quick Reference Guide I 36
35 I Quick Reference Guide
GENESIS GV80
• To turn LKA on,
press the Lane Safety button.
• To turn LKA off,
press the button again.
Lane Keeping Assist detects lane
markers on the road, and helps
prevent the vehicle from departing
the lane while driving.
LANE KEEPING ASSIST (LKA)
LKA operates only when the vehicle
speed is above 37 mph and when the
in the instrument cluster is green.
LKA will not operate properly if the
following conditions are present:
- the lane line is not clear
- on sharp bend in a road
- heavy fog
Refer to the Owner's Manual for more
detailed information.
NOTE: During operation, you
may feel the sensation of steering
wheel movement. Depending on
the road condition(gradient), the
deflection driving may occur. LKA
mode can be adjusted in the
User Settings page of the
infotainment system.
ELECTRONIC PARKING BRAKE (EPB)
PULL
PULL
or
Stop the vehicle then pull
the EPB switch.
PULL
PULL
Applying
Move shift lever from P/N
to D/R while depressing
the brake pedal.
Releasing
Press the EPB switch while
depressing the brake pedal.
PULL
PULL
NOTE: If necessary, emergency braking is
possible by pulling and holding the EPB
switch.
SMART CRUISE CONTROL (SCC)
Adjusting the vehicle speed
1. Push '+' switch
1
UP to increase cruising speed.
2. Push '-' switch
2
DOWN to decrease cruising speed.
NOTE: Quick push up/down will change speed by 1 mph. Holding
switch up/down will change speed by 5 mph.
MODE
MODE
MODE
+
-
MODE MODE MODE
+
-
Smart Cruise Control helps maintain
distance from the vehicle ahead and drive at
a speed, set by the driver.
MODE
MODE
MODE
+
-
MODE MODE MODE
+
-
To turn on SCC:
1. Press the Driving Assist button
to turn on SCC. The speed will be set to
the current speed on the cluster.
2. If there is no vehicle in front of you, the
set speed will be maintained, but if there
is a vehicle in front of you, the speed
may decrease to maintain the distance
to the vehicle ahead. If the vehicle
ahead accelerates, your vehicle will
accelerate.
To set vehicle distance
Each time the button is pressed, the vehicle
to vehicle distance changes as follows:
Distance 2
Distance 3Distance 4
Distance 1
To Cancel Smart Cruise Control
To temporarily cancel SCC
Press the switch or depress the brake
pedal to temporarily cancel SCC.
To turn off the SCC
Press the Driving Assist button to turn
SCC off.
MODE MODE MODE
+
-
MODE MODE MODE
+
-
MODE
MODE
1
2