To Next PageTo Next Page
Need help?Do you have a question about the Genesis XM series and is the answer not in the manual?
Guidance on grounding, disassembly, and safe handling of electrical connections to prevent shock.
Warns against using the UPS in areas with flammable materials due to potential arcs or sparks.
Emphasizes correct battery polarity to prevent fuse blowing and permanent damage to the UPS.
Explains the two levels of power rating: continuous (VA/Watts) and surge (instantaneous overload).
Recommends UPS continuous rating to be at least 2.8 times the SMPS RMS rating for safe operation.
Mandates installation and wiring to follow standard electrical codes and be done by a qualified electrician.
Stresses the importance of connecting the UPS to an appropriate grounding system for electrical safety.
Provides detailed safety measures for handling batteries, covering acid, gas, and tool-related hazards.
Reiterates that UPS AC output should not be synchronized or connected to breaker panels fed by other sources.
Lists essential steps: connect battery, connect mains, switch on input MCB, connect output load.
Highlights critical precautions: avoid reverse polarity, phase/neutral reversal, switching on without battery, or parallel AC output.
Explains that the built-in AVR protects loads from low and high voltage conditions on the main supply.
Informs about the audible alarm given before the UPS trips due to low battery voltage, indicating discharge.
General