Genexis FiberTwist Installation Guide

SSID: Genexis-xxxx
WiFi-Key:
**************
WARNING: POWER RATING:12V 2A
GUI: http://Genexis-xxxx
Username: user
Password: user
Made in China
Model: Pulse
P/N: 99618025
Version: 1.0
Date: 2018-05
Power switch
FiberTwist + Pulse
Network Termination +
WiFi Repeater/Extender
Quick Installation Guide
www.genexis.eu
Revision 1.3. - September 2018
Copyright © 2018 Genexis B.V. All rights reserved.
7. Connect Pulse to FiberTwist
Connect the provided Ethernet cable to a
LAN port of your FiberTwist and to the WAN
(red) port of your Pulse.
8. Connect to the power
Connect the supplied power adapter to your
Pulse and plug the adapter into an
AC power socket.
9. Turn on your Pulse
Turn on your Pulse by fl ipping the switch on
the side of the device.
After approximately 1.5 minutes the Status
LED should turn green and stop blinking.
When the Internet LED becomes yellow, your
Pulse is ready for use.
10. Connect to your Pulse WiFi
Consult the information label at the bottom
of your Pulse. It shows the SSID of the WiFi
network (i.e. GENEXIS-xxxx) and the WiFi
Key. Connect to this WiFi network with your
devices.
You are now connected to the internet.
For more information about your Pulse
or your FiberTwist, have a look at the Full
Installation Guides (https://genexis.eu/
download-portal/#fi bertwist)or
https://genexis.eu/download-portal/#pulse)
or contact your service provider.
Hereby, Genexis declares that the radio
equipment type Pulse is in compliance with
Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the
following internet address:
https://genexis.eu/red/pulse

Genexis FiberTwist Specifications

General

Connector Type	SC/APC
Fiber Count	1
Humidity	5% to 95% (non-condensing)
Operating Temperature	40°C
Category	Network
Type	Fiber Termination
Storage Temperature	-20°C