To Next PageTo Next PageWhy does my Genie 2055 run slow?
Check the operating condition of the door. The door may need professional repair or adjustment. Also, verify if this opener is installed on a one-piece door, as this opener is not designed to operate a one-piece door.
What to do if my Genie Garage Door Opener doesn't operate when the wall control is pressed?
First, turn Sure-Lock™ OFF. Next, check the power source by plugging a lamp into the outlet used for the powerhead; if the lamp works, the power source is OK. If not, check the fuse or circuit breaker. Also, check the connections at the powerhead terminals and at the wall console. Finally, check for reversed, broken, or cut wires, and repair or replace them as needed.
What to do if Genie 2055 starts up, but stops before fully opening?
If the garage door starts to open but stops before it's fully open, check if the limits are properly set. Ensure the door, opener, and springs are in good repair, properly lubricated, and balanced. Also, check the closing/opening “FORCE” control.
What to do if Genie Garage Door Opener starts down, then stops before closing?
If your garage door starts to close but stops before it's fully closed, check the Safe-T-Beam® wire connections at both the powerhead and the STBs. Ensure that the limits are properly set. Also, check the CONTACT REVERSE feature and inspect the garage door for any binding. Finally, check the closing "FORCE" control.
How to fix a Genie 2055 Garage Door Opener that works from the wall control but not the remote?
If your garage door opener operates via the wall control but not the remote, begin by checking all remotes. Replace the remote battery. If that doesn't work, program the remotes to the powerhead.
What to do if my Genie Garage Door Opener starts down, then stops and goes back up?
If this is a new installation, verify the door arm position. Also, check if the limits are properly set. Inspect the Safe-T-Beam® system; a flashing red LED indicates a problem. Ensure there are no obstructions or misalignment of lenses in the Safe-T-Beam® system. Check the garage door for any binding issues. If these steps don't resolve the issue, and you need to close the door, press and hold the wall control button until the door closes completely.
Why is my Genie Garage Door Opener running slowly?
If your Genie door opener is running slowly: * Check the operating condition of the door. The door may need professional repair or adjustment. * Verify that the opener is not installed on a one-piece door, as it is not designed for this type of door.
How to fix Genie 2055 that works with wall control but not remote?
If your Genie garage door opener operates with the wall control but not the remote, here are a few things to try: * Check all remotes. * Replace the remote battery. * Program the remotes to the powerhead.
General| Model | 2055 |
|---|---|
| Horsepower | 1/2 HP |
| Frequency | 60 Hz |
| Battery Backup | No |
| Type | Chain Drive |
| Drive Type | Chain Drive |
| Lighting | 75-watt incandescent bulb (not included) |
| Voltage | 120V |
| Motor Type | AC |
| Security | Rolling code technology |
| Door Compatibility | 7 ft. door (8 ft. with extension kit) |
Details potential hazards associated with garage door operation and safety.
Provides critical safety instructions for operating garage door openers.
Highlights crucial warnings for safe and proper installation of the opener.
Details the buttons and LEDs on the powerhead for programming.
Critical warnings regarding setting the down travel limit.
Instructions on setting and understanding force control.
Table detailing powerhead LED indicators and their meanings.
