To Next PageTo Next Page
Need help?Do you have a question about the Genie CB 1200 and is the answer not in the manual?
General| Type | Chain Drive |
|---|---|
| Horsepower | 1/2 HP |
| Drive Type | Chain |
| Remote Controls | 2 |
| Voltage | 120V |
| Wireless Technology | Intellicode Rolling Code Technology |
| Speed | 7 inches per second |
| Security | Intellicode Rolling Code Technology |
| Battery Backup | No |
| Drive System | Chain Drive |
Key safety warnings and precautions for operating the garage door opener.
Critical instructions for safe and correct installation of the opener.
Prevents door closure if beam is broken.
Stops and reverses door on contact with object.
Automatically sets force for door operation.
Allows manual door operation during power failure.
Advanced encryption for secure remote access.
Controls opener from inside the garage.
How the Safe-T-Beam system works during door closing.
Explains buttons, LEDs, and programming functions on the powerhead.
Sets the down travel limit for the garage door.
Sets the up travel limit for the garage door.
Factory-set controls for door force and speed.
Programming remotes for the opener.
Instructions for setting up, resetting, and changing PINs for the wireless keypad.
How to erase all programmed remotes from the opener's memory.
Setting up remotes to work with Intellicode 1 openers.
Instructions for attaching the door bracket to a one-piece door.
Instructions for attaching the door arm to the door bracket.
Procedure to test and ensure the door reverses correctly on contact.
Verifies the proper functioning of the Safe-T-Beam safety system.
Checks door balance and spring tension for safe operation.
Instructions for replacing light bulbs in the opener.
Guide for replacing the battery in the remote control.
Adjusting the force settings for door operation.
Adjusting the travel speed settings for sectional doors.
Guidance on positioning Safe-T-Beam sensors for optimal performance.
Diagram showing power cord connection and internal circuit board layout.
Wiring for chain and screw drive motors.
Wiring for Safe-T-Beam and wall console connections.
Wiring diagrams for motion detectors and optical sensors.
Solves issues where the opener does not run from the wall console or remote.
Addresses problems with the door not moving or stopping unexpectedly.
Troubleshoots issues related to the Safe-T-Beam system.
Interprets powerhead LED status codes for problem diagnosis.
Details warranty periods for various opener components and accessories.
Outlines conditions and exclusions that may void the warranty.
