Genie Universal Series User Manual

Page 1
ALTERNATE INSTRUCTIONS
UNIVERSAL WIRELESS WALL CONSOLE
UNIVERSAL WIRELESS WALL CONSOLEUNIVERSAL WIRELESS WALL CONSOLE
UNIVERSAL WIRELESS WALL CONSOLE
Alternate instructions for the Teach & Pair Programming Method, for Fixed Code/Dip Switch
Programming and alternate blink rates are to be used in conjunction with the main instruction set.
Changes made to the blue LED blink rate pattern will impact battery life. For best battery life, see Blink Rate
Mode 3 to turn LEDs off completely.
BLUE LED Blink Rate Mode 1: Factory Default Setting
(Blink Rate - Once every 3 sec)
 With only (1) AAA battery installed - hold down the TOP DOOR button while
simultaneously installing the second AAA battery. Continue to hold the TOP DOOR
button for a total of 10 seconds until the blue LEDs on the OTHER 2 BUTTONS blink 3
times in unison.
BLUE LED Blink Rate Mode 2
(Faster Blink Rate - Once every 2 seconds)
 With only (1) AAA battery installed - hold down the MIDDLE DOOR button while
simultaneously installing the second AAA battery. Continue to hold the MIDDLE
DOOR button for a total of 10 seconds until the blue LEDs on the OTHER 2 BUTTONS
blink 3 times in unison.
BLUE LED Blink Rate Mode 3
(Blue LED OFF - Maximum Battery Life)
 With only (1) AAA battery installed - hold down the BOTTOM DOOR button while
simultaneously installing the second AAA battery. Continue to hold the BOTTOM
DOOR button for a total of 10 seconds until the blue LEDs on the OTHER 2 BUTTONS
blink 3 times in unison.
Page 1: Changing Blink Rate Patterns
Page 2: Fixed Code/Dip Switch Programming
Page 3: TEACH & PAIR Programming Method
ALTERNATE INSTRUCTIONS
CHANGING BLINK RATE
CHANGING BLINK RATE CHANGING BLINK RATE
CHANGING BLINK RATE PATTERNS
PATTERNSPATTERNS
PATTERNS

Genie Universal Series Specifications

General

Brand	Genie
Model	Universal Series
Category	Controller
Language	English

Summary

Changing Blink Rate Patterns

Factory Default Blink Rate

Set the blue LED to blink once every 3 seconds as the factory default.

Faster Blink Rate

Configure the blue LED to blink once every 2 seconds for quicker visual feedback.

Maximum Battery Life Mode

Turn off the blue LED completely to maximize battery life.

Dip Switch / Fixed Code Programming

Record Switch Positions

Document the current switch positions on the remote or opener for programming.

Determine Specifications from Chart B

Find the correct number of button presses based on opener specifications in Chart B.

Programming Steps

Step-by-step guide to program the console using dip switch settings and button presses.

Teach & Pair Programming Method

Programming for Most Openers

Instructions for Teach & Pair programming for openers excluding specific Chamberlain/LiftMaster models.

Programming for Chamberlain/LiftMaster/Craftsman

Specific Teach & Pair programming steps for openers with a yellow learn button.