Genius INVICTUS 2.0 - Operation; Application

To Next Page

To Previous Page

Instruction manual

Operation

Fill water tank

DO NOT ADD ANY DESCALING AGENT, AROMAS, CLEANING ADDITIVES, OILS

OR OTHER CHEMICALS INTO THE WATER TANK.

WE RECOMMEND USING DISTILLED WATER TO AVOID DEPOSITS.

SWITCH OFF THE APPLIANCE AND DISCONNECT THE MAINS PLUG FROM

THE SOCKET WHEN FILLING THE WATER TANK.

THE FILLER OPENING MUST NOT BE OPENED DURING USE.

NOTE!

1. Turn the cover of the water tank anti-clockwise to open it (see g. D).

2. Fill the water tank with the measuring cup and close the water tank again with the cover (see g. E).

3. Fill the water tank with distilled water to prevent calcifying.

Application

ONLY USE THE DEVICE WITH A FILLED WATER TANK.

ONLY USE THE DEVICE ON SUITABLE SURFACES.

NOTE!

1. If necessary, unwind the power cable and insert the plug into a functional socket.

2. The three blue LEDs on the main unit ash alternately while the appliance is heating up.

3. As soon as the rst LED lights up solid blue (after approx. 25 seconds), the appliance is ready for operation.

4. The appliance starts automatically with min. steam strength. You can increase the steam strength by pressing the

mode button (see g. F).

1 x press - second LED lights up blue - medium vapour strength

2 x press - third LED lights up blue - max. vapour strength

5. Press the mode button again to switch back to min. vapour strength.

Use as a oor steam cleaner

1. Place the cleaning foot on the oor, step on the side of the cleaning foot with your foot and pull the handle

towards you to activate the steam function (see g. G).

2. Move the cleaning foot over the surface to be cleaned. The cleaning foot should remain in motion while cleaning.

Do not clean the same area for long periods of time.

3. If you place the running appliance in an upright position and the lock on the cleaning foot engages, the steam

function is deactivated and the appliance switches to standby mode. In standby mode, the appliance restarts as

soon as it is placed in an inclined position.

4. For carpet cleaning, place the cleaning foot with the microbre mop pad in the carpet glider. This makes it easier to

move the cleaning foot over the carpet.