21
Instruction manual
GB
Cleaning and care
WARNING!
RISK OF ELECTRIC SHOCK
Switch off the device before cleaning or user maintenance and disconnect it from
the power network.
Never place the device under flowing water and do not submerse in water or
other liquids.
Clean the device by wiping it with a moist towel.
Do not use any sharp or abrasive cleaning agents or cleaning pads.
Store the device in a dry, cool location protected against the sun and outside of the reach of children and animals.
The microber cloth can be washed at 40°C. Do not use any bleach or softener.
Troubleshooting
WARNING!
Switch o the device and remove the plug before xing an error! This may other-
wise lead to injuries or electric shock.
Problem Possible cause Solution
The LEDs do not ash or light up.
No power connection.
Check if the device is connected to a
functional outlet.
Maybe the outlet is defective, try
another one.
Device does not work.
Overheating (for example, due to a lack
of water) lead to the device being shut
down automatically.
Let the device cool down completely, ll
the water tank and try it again.
No steam comes out.
Nozzle is plugged.
Clean the water tank and the nozzle with
standard cleaning agent, the water tank
should be decalcied if necessary.
Use the device with distilled water.
There is no steam and it
makes strange noises.
Water tank is empty. Let the device cool down and ll the
water tank.
It is dicult to move the
cleaning base over the carpet.
Glider not being used . Always use the carpet glider for carpet
cleaning.
To Next Page