CE DECLARATION OF CONFORMITY
Manufacturer: GENIUS S.p.A.
Address: Via Padre Elzi, 32 - 24050 - Grassobbio- Bergamo - ITALY
Declares that: The control unit mod. LYNX 07 24V
conforms to the essential safety requirements of the following EEC directives:
2006/95/EC Low Voltage directive.
2004/108/EC Electromagnetic Compatibility directive
Additional information:
This product underwent a test in a typical uniform configuration (all products manufactured by GENIUS S.p.A.)
Grassobbio, February 22, 2010
The Managing Director
D. Gianantoni
•
•
•
Notes on reading the instruction
Read this installation manual to the full before you begin installing the product.
The symbol indicates notes that are important for the safety of persons and for the good condition of the
automated system.
The symbol draws your attention to the notes on the characteristics and operation of the product.
INDEX
1. GENERAL CHARACTERISTICS page.17
2. TECHNICAL SPECIFICATIONS page.17
3. PREPARATIONS page.17
4. BOARD LAYOUT page.17
5. CONNECTIONS AND OPERATION page.18
5.1. CN1 TERMINAL BOARD page.18
5.2. CN2 TERMINAL BOARD page.18
5.3. CN3 TERMINAL BOARD page.18
5.4. CN4 TERMINAL BOARD page.19
5.5. CN5 TERMINAL BOARD page.20
5.6. JP2 CONNECTOR page.20
5.7. JP3 CONNECTOR page.20
6. MEMORY STORING THE RADIO CODE page.20
6.1. Memory storing the 868 MHz radio controls page.20
6.2. Memory storing the 433 MHz radio controls page.21
6.3. Deleting the radio codes page.21
7. CONTROL LEDs page.22
8. OPERATION OF THE DISPLAY page.22
9. OPERATING PARAMETERS page.22
9.1. Resetting the cycle number for service request page.25
10. PROGRAMMING page.26
11. PROTECTIVE FUSES page.26
12. OPERATING LOGICS page.27
To Next Page
Loading...
