31
Instruction Manual
GB
Place the cutter base on the collecting container and lock it into
place with an audible click. Then insert the Nicer Slicer at an angle of
90° (vertically) into the cutter base in the side slots provided.
Then unfold the Nicer Slicer so that it is xed in the frame of the
cutter base.
Removal
The Nicer Slicer can only be removed if it is in the vertical (90°)
position.
Put the Nicer Slicer in the vertical position and pull upwards while
holding down the cutter base with the other hand.
5.3 Setting the cutting thickness
With the aid of the thickness controller on the bottom of the Nicer Slicer, the height-adjustable feed plate
can be custom-set to achieve the required thickness.
Cutting thickness controller:
Setting the cutting thickness
Clockwise: Lifting the feed plate for thinner slices
Counter clockwise: Lowering the feed plate for thicker slices
Julienne controller:
To extend or retract the Julienne blades
Position : Julienne blades are extended: Cutting Julienne strips
Position : Julienne blades are retracted: Cutting slices
To Next Page
Loading...
Need help?
General
Weight and Dimensions
