Genius SW-2.1 355 User Manual

Se
rv
ic
e G
ui
de
SW-2.1 355
6.1 Packing requirement for sending the PCB assembly by post
PCB assembly is a kind of sophisticated electronic circuit board.
Well packing will be required when sending them by post.
*Some sophisticated IC components are mounted on the PCB
assembly; hence it is necessary to pack each PCB assembly
with a separate static protecting bag, in order to avoid static
electricity.
*Reliable external packing is also very important when sending
the PCB assembly by post, in that it would avoid unnecessarily
lost or damage.
6.2 Short of spare parts while repairing a speaker system
If you are short of spare parts when you have some speaker
systems waiting to be repaired, it would be recommended to take
the necessary parts from one
Speaker system, so that you may have the as many speaker
systems
Version
1.0
Page
19
of
20
C
h
a
t
e
r
6
.
I
m
o
r
t
a
n
t
N
o
t
e
s

Genius SW-2.1 355 Specifications

General

Speaker Type	2.1
Signal-to-Noise Ratio	70 dB
Volume Control	Yes
Input Sensitivity	450mV
Total Power Output	10 W
Frequency Response	20Hz - 20kHz
Input	3.5mm stereo
Input Impedance	10k ohms
Controls	Volume
Power Supply	AC
Driver Unit	Subwoofer: 4"; Satellite: 2.5"