Genius SW-2.1 355 User Manual

S
e
rvi
ce G
ui
de
SW-2.1 355
*Attention
Please follow the numbered sequence marked within parenthesis given in
individual
Flow chat in that this is the
best-recommende
d sequence to rectify the problems.
1.2.1 No power
Problem
Analyze
and
identify
the
causes
Solutions
Version
1.0
Page
7
of
20
Defective soldering of transformer
secondary
wire
and
CON4
on
PCB
board
No power
，
LED
（
indicator
）
unlighted
Repair or replace
resolder or replace
Repair or replace
Defective or
damaged AC cable,
or power switch
Defective
transformer
LED indicator
unlighted

Genius SW-2.1 355 Specifications

General

Speaker Type	2.1
Signal-to-Noise Ratio	70 dB
Volume Control	Yes
Input Sensitivity	450mV
Total Power Output	10 W
Frequency Response	20Hz - 20kHz
Input	3.5mm stereo
Input Impedance	10k ohms
Controls	Volume
Power Supply	AC
Driver Unit	Subwoofer: 4"; Satellite: 2.5"