Chapter III. Usage and Maintenance
F1 at this time and upon doing it, you will be
presented with the BIOS Settings Screen. If Windows
begins to load, you have missed the chance and need to
restart the computer and try again. In the BIOS Setup
Screen, locate and go to the Input/Output (I/O) Ports
settings. Locate the setting for Parallel Port Mode.
Preferred Parallel Port Modes for the Scanner (best is
first):
1. EPP
2. ECP + EPP
3. Bi-directional
4. SPP (or normal/standard)
First, try to set the Parallel Port Mode to EPP.
This is the best setting for the scanner. If it is not
available, try ECP + EPP, and so on down the list.
Exit and Save the changes to the BIOS settings and
after loading Windows, run the Scanner Utility
program again.
To Next Page
Loading...
