28
GB
Instruction manual
Wall Mount
Ax the wall mount to the wall using the supplied screws. Ensure that there are no pipes or electric
cables behind the screw insertion points in the wall.
The recesses on the mount can be used for cable storage to prevent the charging cable from hanging on
the oor when not in use.
Emptying the dust container
1. Switch o the vacuum cleaner.
2. Empty the container when the maximum line is reached at the latest.
3. Hold the appliance with the dust container over a dustbin. Press the release of the dust container so
that the ap swings down and the dirt falls out (g. H).
4. Close the lid properly.
Charging station
Specially designed for the space-saving and safe storage of the appliance. Remove the tube from the
main unit and place it on the charging station as illustrated (g. G). There is a recess on the front side
for the motorized power brush (with or without tube) and 2 accessory holders.
Also has a battery charging function (See: Charging the battery).
Improper handling of the device can cause damage to the device. Clean ALL lters regularly to maintain
suction power.
1. Switch of the vacuum cleaner.
2. Remove the dust container (g. I) (please also refer to the ‘Emptying the dust container’ section).
3. Remove the cyclone lter (b) by turning it clockwise (g. M).
4. Remove the pre-motor lter (c),by removing it from the top of the hand unit (g. J).
5. Remove the HEPA lter (g. K).
6. Clean the lters (please also refer to the ‘Cleaning’ section).
7. Put the lters back into the handset and reattach the dust container.
Removing the cyclone/pre-motor and HEPA lter
NOTE!
Replace the HEPA lter at intervals of approx. 6 months.
NOTE!
RISK OF DAMAGE!
To Next Page
Loading...
Need help?
General
