27
Instruction manual
GB
Charging the battery
NOTE!
1. Ensure that the appliance cleaner is switched o.
2. To charge the battery, connect the charging socket (k) to a suitable power outlet using the mains adapter
(g. D).
Or
Remove the battery from the main unit by pressing the release button (o) at the end of the battery and pulling it
out (g. E). Connect the storage unit to a suitable power outlet using the included mains adapter and insert the
battery in the appropriate recess (g. F).
3. The charging display (d) ashes blue during charging.
4. Once the battery is fully charged, the charging display stops ashing.
Attaching and removing the suction tube / brushes / accessories
Slide the suction tube onto the opening of the handset until it clicks into place. To remove it, press the release
button and pull the suction tube away from the handset (g. B).
The electric brush, mini electric brush and UV light brush must be powered for proper operation. These
attachments must therefore be mounted either on the suction tube or directly on the hand-held unit. To do this,
attach the respective attachment. To remove, press the release button and remove the attachment (g. C).
All other accessories can be directly connected to the main unit or, to increase the appliance‘s reach, to the tube,
the extension hose and the multi-angle adapter.
Use
Cleaning carpets and hard oors
Read the manufacture’s care instructions before cleaning oors and carpets.
Rotating brushes can cause damage to some carpets and oors. Some carpets pill when cleaned with
rotating brushes. Test an inconspicuous area of the oor or carpet before cleaning it.
Before cleaning polished oors (wood, linoleum etc.) ensure that there are no foreign bodies on the
underside of the motorized power brush that might cause scratches.
Switching the appliance on and o – boost button
Use the on/o button to switch the vacuum cleaner on and o (i). It continues operating until you
release the button. You can also use the locking lever for continuous operation.
Press the boost button (e) to maximise suction. When the appliance is switched o, boost mode is
automatically deactivated. You can also deactivate boost mode by pressing the boost button again.
Charge the battery with the supplied charging
cable only. Always use original batteries.
Assembling the charging station
1. Place the holder on the recess on the front of the storage station.
2. Tighten the bracket with the included screw.
To Next Page
Loading...
Need help?
General
