32
08 Frequently Asked Questions
FAQQUESTIONS TYPE
Machine Related
Questions
Engraving/Cutting
Related Questions
SOLUTION
Why can't the machine connect to
the computer after it is powered
on?
Can it be engraved on
reflective/transparent materials such
as ceramics/glass?
What non-transparent materials
canL8 laser engraving machine
engrave or cut?
Why can't I use the mobile phone
after the machine is powered on?
Can it be engraved on curved
surface materials?
c. Close other software that occupies the com port. When you use
Lasergrbl to connect, you cannot connect when you open CutLabX.
You need to close Lasergrbl to use it normally.
Note: In Lightburn, the machine can store multiple machine
information, please select the appropriate configuration information
according to the model.
a. Please use the mobile phone according to the manual.
b. If the connection is abnormal due to the incompatibility of the
newly released mobile phone or the upgraded system, please
provide a screenshot of the mobile phone configuration and contact
our customer service to get technical support as soon as possible.
Engraving: cardboard, wood, bamboo, rubber, leather, fabric,
acrylic, painted metal, plastic, etc.;
Cutting: cardboard, wood, bamboo, cloth, leather, fabric, acrylic
(cannot cut clear acrylic), plastic, etc.
Yes, but the radian of the material and the engraved graphic area
should not be too large, otherwise there will be slight deformation.
Yes, but before engraving, it is necessary to coat the surface of the
material with anti-reflective material (such as laser color paper,
black marker pen) to ensure the engraving effect and prevent the
reflected light from damaging the laser module.
To Next Page
Loading...
