Need help?Do you have a question about the Genmitsu PROVerXL 4030 V2 and is the answer not in the manual?
Confirm Y-axis roller module position by measuring and adjusting distances for proper alignment.
Mount the X-axis module onto the XY axis base module using the provided screws.
Mount the XZ axis module onto the X-axis module using screws, flat washers, and spring washers.
Insert the X-axis coupler onto the lead screw and the motor shaft, then secure with screws.
Install Y-axis drag chain brackets A and B using appropriate socket head cap screws.
Attach the Y-axis drag chain to its brackets and secure it with flat head cap screws.
Install X-axis drag chain brackets A and B using appropriate socket head cap screws.
General| Model Name | PROVerXL 4030 V2 |
|---|---|
| Control Board Compatibility | GRBL 1.1h |
| MCU | 8-Bit |
| Stepper Driver | WSD6056DN56 |
| X, Y,Z Axis Motor | NEMA 23, 76mm, Closed-loop Stepper Motor |
| X&Y Axis Transmission | 1204 Ball Screw |
| Z Axis Transmission | 12mm Linear Shaft & 1204 Ball Screw |
| Max Speed | 5000mm/min |
| Running Accuracy | Circular: ≤ ±0.05mm; Rectangle: ≤ ±0.02mm |
| Repositioning Accuracy | ≤ ±0.05mm |
| Torque | 2.2N・m |
| CAM Software | Software Based on GRBL Firmware, e.g. Candle, UGS |
| Spindle Power | MAX 400W 10000RPM |
| Spindle Voltage | DC, 0-48V Adjustable |
| Power Supply | 48V 7A & 24V 8A |
Weight and Dimensions| Work Area | 400 x 300 x 110mm (15.75" x 11.81" x 4.33") |
|---|---|
| Overall Dimensions | 740 x 605 x 488mm (29.13" x 23.82" x 19.21") |
| Body Material | Metal Frame & Hybrid Spoilboard |
To Next Page
