PAGE 4 GENQUIP GI3300ER DSP INVERTER GENERATOR
Control Panel Key and Description (Electric Start Model)
1. Carry Handles
2. Fuel Level Gauge
3. Fuel Cap and Vent
4. Fuel On and Off Switch
5. AC Ready Pilot Light
6. Oil Warming Light
7. Ground (Earth) Terminal
8. 240 Volt Sockets
9. Engine On and Off Switch
10. Recoil Stater
11. Transport Handle
12. 12V DC Outlet and Reset Button
13. Access Door Panel
14. Electric Key Start
Control Function (Remote Start Model)
1
9
10
11
2 3 1
14
12
134
6 5 7 8
page 5Genquip Gi3300 DSP Inverter Generator
Pre-Operation Checklist
Note: Pre-operation checks should be carried out each time the generator is used.
Fuel System
Make sure there is sufficient fuel in the tank. The engine uses regular unleaded petrol
only. The fuel tank capacity is 7 litres.
Refuelling & Fuel Level Gauge
To refuel, remove cap and fuel slowly until fuel gauge indicates full. Apply fuel cap.
WARNING: Fuel is high flammable and poisonous.
DO NOT fill above the top of fuel filler or it may
overflow when the fuel heats up and expands.
Wipe up any spilled fuel immediately.
After refuelling, make sure the tank cap is tightened.
Engine Oil
Make sure the engine oil is at the upper level of the oil filler hole. Add oil as necessary.
Recommended oil for most climates is 10W30. Engine oil quantity is 600 millilitres.
Fuel Cap
Fuel Level Gauge
“F” Full
“E” Empty
To Next Page
Loading...