Genquip Gi3300ER - Operation; Starting the Engine

GENQUIP GI3300ER DSP INVERTER GENERATOR PAGE 7
page 6 Genquip Gi3300 DSP Inverter Generator
Control Function
Oil Warning System
If the oil level falls below the safe operating level, the engine will stop automatically.
Unless you refill with oil, the engine will not start again.
Note: If the engine stalls or does not start, turn the engine switch to “ON” position and
then pull the recoil starter. If the oil warning light flickers for a few seconds, the engine oil
is low. Add oil and restart.
Engine Switch
The engine switch controls the ignition system.
A. Ignition circuit is switched on.
The engine can be started.
B. Ignition circuit is switched off.
The engine will not run.
DC Protector
The DC Protector turns off automatically when the load exceeds the generator’s rated
output.
Note: If the DC Protector trips to the OFF position, press to reset. Reduce the load to
the specified generator output if the DC protector turns off. If it turns off again, consult
the authorized dealer.
A
B
O N
S TO P
ON
(PUSH)
PROTECTOR
OFF
page 7Genquip Gi3300 DSP Inverter Generator
Operation
Starting The Engine
Note:
Before starting the engine, do not connect any electric devices.
1. Turn the fuel switch lever to the “ON” position.
2. Turn the engine switch to the “ON” position.
O
O
O
O
.
.