Gentex Full Display Mirror - Page 3

Plug mirror
power
harness
into
the
back
of
the
mirror.
Find 12V switched
ignition
and attach
t-tap
using
pliers.
Repeat for
12V battery and
ground
supply. Ensure
t-tap
is
snapped
together
.
Route
the
mirror
power harness
to
location
where 12V ignition,
12V battery, and ground
lines
are
located.
Secure harness
along
route
with
foam tape and/or cable ti
es.
*
Commonly
found
in
overhead, A
pillar,
or
junction
block.
3/9
Bla
ck
w/
or
ange:
12V Ba
tt
e
ry
-
Plug
mirror
's power harness ignition wire
into
t-tap. Repeat for
battery and ground. Ensure
the
spade
is
properly
seated
into
t-tap.