8. Remove the right or left front housing screw where the inner visor knob is to
be located. Use a screwdriver to lift the upper track just enough to provide
clearance for the inner visor knob. Slide the inner visor into the lower tracks.
9. Realign the left (or right, as applicable) front tracks and spacer over post.
Insert the screw and tighten it securely.
10. Tighten the remaining three screws securely.
11. Test the outer visor operation by using outer visor lock. Test the inner visor
operation by using the inner visor knob. If either visor does not move freely,
loosen the screws, hold the visor housing at the sides, and move the housing
side to side as required to achieve smooth operation of both visors.
Re-tighten the screws.
12. To move the outer visor lock from one side to the other, follow these steps:
a. Move the inner visor down about halfway.
b. Disassemble the outer visor lock and remove the visor key.
c. Move the visor key to the cutout on other side of the visor and install it
as in step 9. Assemble the visor lock, washer, and center screw as in
step 9. Test the visor for proper operation.
13. To move the inner visor knob from one side of the housing to the other,
follow these steps:
a. Remove the front housing screw on the side where the visor knob is
located.
b. Lifting the upper track slightly, slide the inner visor out of the tracks.
NOTE
Before reinstalling screws in Steps c and d, apply one or two
drops of Weldwood glue #281 or equivalent to the first two
threads of each screw.
c. Remove the screws and posts attaching the knob to the visor; move the
knob to the holes on the other side of the visor and reattach it with the
screws and posts.
d. Remove the front screw on other side of the housing; lift the upper track
slightly and reinsert the visor into the lower track. Realign the front of
the visor assembly and reinstall the front screws. Tighten the screws
securely. Test the visors for proper operation.
23
To Next Page
Loading...
